Replacing glass shower door sweep install#

Since many of the frameless shower glass doors are customized, the horizontal door length may be different in every case. Since this length is much longer, using a tape measurer will make this process much simpler. Next, you'll need to measure the horizontal length of the shower door. If you don't have one, a simple ruler should do the trick.

Before you order, it's a good idea to confirm the thickness of the shower glass door by measuring with a tape measurer. Because of this, the frame-less shower glass is thicker at 3/8'. That means there are no metal bars above or on the sides that support the glass. In my case, we have a frameless shower enclosure. Simply snap off the existing shower door seal, do a bit of cleaning, and snap on the new shower door seal. And it turns out, it's the easiest DIY project, involving almost no tools. Afraid that it more than accumulated dirt and that it could be mold, I decided it was time to replace it. Despite our efforts in keeping the glass clean with periodic cleaning of the water stains off the glass and removing mildew on the grout between the shower tiles, the sweep at the bottom of the shower door that creates a seal to prevent water from splashing out of the shower slowly turned darker and darker. It's the bathroom, and specifically the shower we use daily each and every morning.

We love our frameless shower enclosure in our master bathroom.

Replacing glass shower door sweep install#

As a back up, you may want to install three small self-tapping water-resistant screws (like galvanized or brass) through the drip edge into the door.įinally, some drip edges have a stop built in at the swinging side of the door.The links in this post contain affiliate links and I will receive a small commission if you make a purchase after clicking on my link. Apply a second small bead of caulk at the top of the drip edge where it meets the door and smooth it with a wet finger. If you have this type of drip edge, apply a bead of clear silicone caulk to the back lip of the drip edge and push it back into place. I don't particularly like sweeps that are secured with caulk only, because they seem to work themselves loose quickly. These sweeps are likely to be held in place with silicone caulk. Some types of drip edges have a groove that the sweep slides into. If the sweep needs to be replaced, buy a new one at a home improvement or plumbing supply store and sandwich it in between the door and drip edge (you may have to trim it). To adjust the sweep, loosen the screws (don't remove them), and pull the sweep down evenly so that it just touches the bottom track of the shower. If your drip edge is held in place with screws, this job is easy. It will probably be a little wavy but that's OK. The drip edge and sweep are usually held in place with a couple of screws, but I have seen them held in place with silicone caulk or even double-sided tape. The sweep can be adjusted or replaced to eliminate this gap. Often, the friction from opening and closing the door will cause the shower sweep to recede up into the drip edge, leaving a gap for water to splash through. The sweep typically rubs against the bottom track of the shower. The nice thing though is that it's permanent. You know how when you open the door from the inside of the shower you sometimes have to push a little harder than normal? That extra effort pushed all those chemicals on the carpet, leaving a rainbow arc of discoloration. The chemicals worked their way down to the drip edge. Well, I got a little lax on squeegeeing the glass after a shower so she bought some chemicals to spray on the glass to leave a streak-free surface. Now, my wife is a cleaning fanatic who goes ballistic if there is even a drop of water on the glass, so she bought a squeegee. The sweep attaches to the inside bottom of the door and has a drip edge to direct water back into the shower, and a rubber sweep on the bottom of the door to keep water from splashing out. Like many people, I have a glass shower door with a sweep on the bottom of it. How can I prevent the water from leaking out? - Shawn L.ĭEAR SHAWN: Most of the complaints I hear about leaking shower doors are that they leak from underneath the door (like yours). My neighbor came over and said it looks like my shower door is missing a part at the bottom of it. DEAR MIKE: I have a problem with water creeping under my shower door when I shower.